This record describes sub bottom profiler data collected on RV Investigator voyage IN2016_V06, 'Sustained monitoring of the EAC: mass, heat and freshwater transports' which departed Brisbane on the 29th October 2016 and returned to Brisbane on the 13th November 2016. The Kongsberg SBP120 (sub bottom profiler) was used to acquire data containing the specular reflections at different sediment interfaces below the seafloor. The SBP120 provides a 3° by 3° angular resolution. The echosounder's frequency sweep range is from 2.5 to 7 kHz. The SBP120 was logged sporadically for the extent of the voyage. Data are stored in .raw 17 files 1.2 GB raw and .seg 17 files 1.2 GB segy formats at CSIRO. The segy format data had a real time processing stream applied, which applies gain, a gain correction, matched filter with replica shaping, an attribute calculation for instantaneous amplitude and time variable gain. Additional information regarding this dataset is contained in the GSM data acquisition and processing report. Additional data products may be available on request

This record describes sub bottom profiler data collected on RV Investigator voyage IN2015_C02,Great Australian Bight Research Program: GAB deep-water pelagic and benthic ecosystem study which departed Port Lincoln on the 30 November 2015 and returned to Fremantle on the 22 December 2015. The Kongsberg SBP120 (sub bottom profiler) was used to acquire data containing the specular reflections at different sediment interfaces below the seafloor. The SBP120 provides a 3° by 3° angular resolution. The echosounder's frequency sweep range is from 2.5 to 7 kHz. The SBP120 was logged for a short (3 hour) period while departing Port Lincoln. SBP120 data was not collected for the remainder of the voyage. Data are stored in .raw (16 files 250 MB) raw and .seg (16 files 249 MB) segy formats at CSIRO. The segy format data had a real time processing stream applied, which applies gain, a gain correction, matched filter with replica shaping, an attribute calculation for instantaneous amplitude and time variable gain. Additional information regarding this dataset is contained in the GSM data acquisition and processing report. Additional data products may be available on request

This record describes sub bottom profiler data collected on RV Investigator voyage IN2025_V04, ['Untangling the causes of change over 25 years in the southeast marine ecosystem - Voyage IV'] which departed Hobart on 27/05/2025 and returned to Hobart on 28/06/2025. The Kongsberg SBP29 (sub bottom profiler) was used to acquire data containing the specular reflections at different sediment interfaces below the seafloor. The SBP29 provides a 3° by 3° angular resolution. The echosounder's frequency sweep range is from 2 to 9 kHz. The SBP29 was logged continuously on the shelf for the extent of the voyage. Data are stored in .raw (1,111 files 26.7 GB) raw and .seg (1,094 files 26.3 GB) segy formats at CSIRO. The segy format data had a real time processing stream applied, which applies gain, a gain correction, matched filter with replica shaping, an attribute calculation for instantaneous amplitude and time variable gain. Additional information regarding this dataset is contained in the GSM data acquisition and processing report. Additional data products may be available on request

This record describes sub bottom profiler data collected on RV Investigator voyage IN2016_V01,'HEOBI: Heard Earth-Ocean-Biosphere Interactions' which departed Fremantle on the 8th January 2016 and returned to Hobart on the 27th February 2016. The Kongsberg SBP120 (sub bottom profiler) was used to acquire data containing the specular reflections at different sediment interfaces below the seafloor. The SBP120 provides a 3° by 3° angular resolution. The echosounder's frequency sweep range is from 2.5 to 7 kHz. The SBP120 was logged continuously for the extent of the voyage. Data are stored in .raw (280 files 39.2 GB) raw and .seg (280 files 38.9 GB) segy formats at CSIRO. The segy format data had a real time processing stream applied, which applies gain, a gain correction, matched filter with replica shaping, an attribute calculation for instantaneous amplitude and time variable gain. Additional information regarding this dataset is contained in the GSM data acquisition and processing report. Additional data products may be available on request

This record describes sub bottom profiler data collected on the RV Investigator voyage IN2023_V04, International nutrient inter-comparison Voyage (INIV) which departed Hobart on the 05/06/23 and returned to Hobart on the 18/06/23. The Kongsberg SBP120 (sub bottom profiler) was used to acquire data containing the specular reflections at different sediment interfaces below the seafloor. The SBP120 provides a 3° by 3° angular resolution. The echosounder's frequency sweep range is from 2.5 to 7 kHz. The SBP120 was logged sporadically for the extent of the voyage. Data are stored in .raw (247 files 5.39 GB) raw and .seg (255 files 5.34 GB) segy formats at CSIRO. The segy format data had a real time processing stream applied, which applies gain, a gain correction, matched filter with replica shaping, an attribute calculation for instantaneous amplitude and time variable gain. Additional information regarding this dataset is contained in the GSM data acquisition and processing report. Additional data products may be available on request.

This record describes sub bottom profiler data collected on RV Investigator voyage IN2017_V03, 'Sampling the abyss: latitudinal biodiversity patterns along the base of Australia’s eastern continental margin' which departed Bell Bay on the 15 May 2017 and returned to Brisbane on the 16 June 2017. The Kongsberg SBP120 (sub bottom profiler) was used to acquire data containing the specular reflections at different sediment interfaces below the seafloor. The SBP120 provides a 3° by 3° angular resolution. The echosounder's frequency sweep range is from 2.5 to 7 kHz. The SBP120 was logged mainly on transits as all ship's acoustics were turned off to listen for beacons on most operations. Data are stored in .raw and .seg formats at CSIRO (30 lines 7.0 GB) The segy format data had a real time processing stream applied, which applies gain, a gain correction, matched filter with replica shaping, an attribute calculation for instantaneous amplitude and time variable gain. Additional information regarding this dataset is contained in the GSM data acquisition and processing report. Additional data products may be available on request

This record describes sub bottom profiler data collected on RV Investigator voyage IN2017_C01, 'GAB deep water geological and benthic ecology program' which departed Hobart on the 11 April 2017 and returned to Hobart on the 28 April 2017. The Kongsberg SBP120 (sub bottom profiler) was used to acquire data containing the specular reflections at different sediment interfaces below the seafloor. The SBP120 provides a 3° by 3° angular resolution. The echosounder's frequency sweep range is from 2.5 to 7 kHz. The SBP120 was logged continuously for the extent of the voyage. Data are stored in .raw 258 files 5.58 GB raw and .seg 258 files 5.41 GB segy formats at CSIRO. The segy format data had a real time processing stream applied, which applies gain, a gain correction, matched filter with replica shaping, an attribute calculation for instantaneous amplitude and time variable gain. Additional information regarding this dataset is contained in the GSM data acquisition and processing report. Additional data products may be available on request

This record describes sub bottom profiler data collected on RV Investigator voyage IN2017_C02, ['Hogan Group Hydrographic Survey – Bass Strait'] which departed Hobart on the 4th May 2017 and came alongside Bell Bay following completion of the survey on the 14th May 2017. The Kongsberg SBP120 (sub bottom profiler) was used to acquire data containing the specular reflections at different sediment interfaces below the seafloor. The SBP120 provides a 3° by 3° angular resolution. The echosounder's frequency sweep range is from 2.5 to 7 kHz. The SBP120 was logged sporadically for the extent of the voyage. Data are stored in .raw and .seg formats (4537 files 70 GB) at CSIRO. The segy format data had a real time processing stream applied, which applies gain, a gain correction, matched filter with replica shaping, an attribute calculation for instantaneous amplitude and time variable gain. Additional information regarding this dataset is contained in the GSM data acquisition and processing report. Additional data products may be available on request

This record describes sub bottom profiler data collected on RV Investigator voyage IN2018_T01, titled: "Physical and biogeochemical gradients in the East Australian Current." The voyage took place from Hobart (TAS) to Brisbane (QLD) between April 5 and April 14, 2018. The Kongsberg SBP120 (sub bottom profiler) was used to acquire data containing the specular reflections at different sediment interfaces below the seafloor. The SBP120 provides a 3° by 3° angular resolution. The echosounder's frequency sweep range is from 2.5 to 7 kHz. The SBP120 was logged sporadically for the extent of the voyage. Data are stored in .raw (24 files 3.42 GB) raw and .seg (29 files 3.4 GB) segy formats at CSIRO. The segy format data had a real time processing stream applied, which applies gain, a gain correction, matched filter with replica shaping, an attribute calculation for instantaneous amplitude and time variable gain. Additional information regarding this dataset is contained in the GSM data acquisition and processing report. Additional data products may be available on request

This record describes sub bottom profiler data collected on RV Investigator voyage IN2017_V02, 'SOTS: Southern Ocean Time Series automated moorings for climate and carbon cycle studies southwest of Tasmania' which departed Hobart on the 17 March 2017 and returned to Hobart on the 28 March 2017. The Kongsberg SBP120 (sub bottom profiler) was used to acquire data containing the specular reflections at different sediment interfaces below the seafloor. The SBP120 provides a 3° by 3° angular resolution. The echosounder's frequency sweep range is from 2.5 to 7 kHz. The SBP120 was logged sporadically for the extent of the voyage. Data are stored in .raw (18 files 142 MB) raw and .seg (19 files 141 MB) segy formats at CSIRO. The segy format data had a real time processing stream applied, which applies gain, a gain correction, matched filter with replica shaping, an attribute calculation for instantaneous amplitude and time variable gain. Additional information regarding this dataset is contained in the GSM data acquisition and processing report. Additional data products may be available on request