This record describes the ADCP data collected from the Marine National Facility (MNF) RV Investigator Voyage IN2020_V10, titled "MNF Trials, Storm Bay Modelling and Information System Data Collection, and Bathymetric and Benthic Habitat mapping of the Huon AMP." The voyage took place between November 13 and November 21, 2020 departing from Hobart (TAS) and arriving in Hobart. Data was collected during in2020_v10 for the duration of the voyage. Data was collected using UHDAS and post-processed using CODAS. Both the RDI Ocean Surveyor 150kHz ADCP and the RDI Ocean Surveyor 75kHz ADCP were run in narrowband. Internal triggering was used. This dataset was processed and then archived within the CSIRO National Collections and Marine Infrastructure (NCMI) Information and Data Centre (IDC) in Hobart.

This record describes the Underway (UWY) data collected from the Marine National Facility (MNF) RV Investigator Voyage IN2018_V01, titled: "Detecting Southern Ocean change from repeat hydrography, deep Argo and trace element biogeochemistry & CAPRICORN." The voyage took place between January 11 and February 21, 2018 departing from Hobart (TAS) and arriving in Hobart. Standard Underway data is continuously recorded, consisting of: (1) Navigation data (NAV): Latitude, Longitude, Speed, Heading, Course Over Ground, Gyros, and Doppler Log (dual GPS instrument). (2) Thermosalinograph (TSG): Water Salinity, Flow-Rate, Temperature, Fluorescence, pCO2, Optode temperature and Oxygen. (3) Atmospheric (MET): Humidity, Wind Speed and Direction (vane and ultrasonic), Radiometer/Sea Surface Temperature, Pyranometer/Solar Radiation, Photosynthetically Active Radiation (PAR), Air Temperature, Air Pressure, Rain, Ozone and Trace Gases (port and starboard instruments). Data are recorded at 5 second intervals. Near real-time data are available via the link "Visualisation tool for Underway Data." This dataset has been processed and archived within the CSIRO Oceans & Atmosphere (O&A) Information and Data Centre (IDC) in Hobart (TAS). Data are available at time intervals of 5 sec (NetCDF format), 10 sec and 5 min (csv format). Additional information regarding this dataset is contained in the Voyage Summary and/or the Data Processing Report for this voyage.

This record describes the Underway (UWY) data collected from the Marine National Facility (MNF) RV Investigator voyage IN2022_V03, titled "SOTS: Southern Ocean Time Series automated moorings for climate and carbon cycle studies southwest of Tasmania". The voyage took place between May 4 and May 15, 2022 departing from Hobart (TAS) and returning to Hobart (TAS). Standard Underway data is continuously recorded, consisting of: (1) Navigation data (NAV): Latitude, Longitude, Speed, Heading, Course Over Ground, Gyros, and Doppler Log (dual GPS instrument). (2) Thermosalinograph (TSG): Water Salinity, Flow-Rate, Temperature, Fluorescence, pCO2 and Optode/Oxygen. (3) Atmospheric (MET): Humidity, Wind Speed and Direction (vane and ultrasonic), Radiometer/Sea Surface Temperature, Pyranometer/Solar Radiation, Photosynthetically Active Radiation (PAR), Air Temperature, Air Pressure, Rain, Ozone and Trace Gases (port and starboard instruments). The quality-controlled RV Investigator underway meteorological and SST data are supplied to the IMOS AODN and other global data repositories and distributors, and made available for satellite SST validation by the Australian Bureau of Meteorology (BoM). Near real-time, unprocessed data are available via the link "Visualisation tool for Underway Data." This dataset has been processed (quality-controlled), and archived by the CSIRO National Collections and Marine Infrastructure (NCMI) Information and Data Centre (IDC). Data are available at time intervals of 5 sec (NetCDF format), 5 sec, 10 sec, 1 min and 5 min (ASCII format). Note: not all variables are quality controlled; please check for existing QC flags in the datasets. Additional information regarding this dataset is contained in the Voyage Summary and/or the Data Processing Reports for this voyage.

This record describes ME 70 scientific multibeam fisheries echosounder data collected on the Marine National Facility (MNF) RV Investigator voyage IN2025_V04, titled "Untangling the causes of change over 25 years in the southeast marine ecosystem - Voyage IV." The voyage took place between May 27, 2025 and June 28, 2025 (AEST), departing from Hobart and returning to Hobart. The Simrad ME70 scientific multibeam echosounder acquired acoustic backscatter data through the water column up to 500 m (maximum). The echosounder's frequency range is from 70 kHz to 120 kHz. The ME70 logged sporadically only for specific trawling operations for the extent of the voyage. Data are stored in Simrad *.all raw format at CSIRO. There are 519 files totalling 60.2 GB of raw data in this dataset. No processing has been conducted on this data. Additional information regarding this dataset, including the settings used, is contained in the GSM data acquisition and processing report. Additional data products may be available on request.

This record describes the Acoustic Doppler Current Profiler (ADCP) data collected from the Marine National Facility RV Investigator voyage IN2021_V04, titled "Biodiversity Assessment of Australia’s Indian Ocean Territories." The voyage took place between June 30 and July 29, 2021 departing from Darwin (NT) and returning in Hobart (TAS). Data was collected during in2021_v04 for most of the voyage. The OS75 was turned off whilst in shallower water to prioritise mapping and the OS150 was turned off briefly for mapping around Christmas Island. Data was collected using UHDAS and post-processed using CODAS. Both the RDI Ocean Surveyor 150kHz ADCP and the RDI Ocean Surveyor 75kHz ADCP were run in narrowband. Internal triggering was used. The drop keel was at 2m below the waterline for the duration of the voyage. See the voyage computing and electronics report for more details regarding data acquisition. This dataset was processed and then archived within the CSIRO National Collections and Marine Infrastructure (NCMI) Information and Data Centre (IDC) in Hobart.

This record describes the Underway (UWY) data collected from the Marine National Facility (MNF) RV Investigator voyage IN2023_V05, titled: "Untangling the causes of change over 25 years in the southeast marine ecosystem (SEA-MES Voyage 1)." The voyage took place between June 27, 2023 and July 29, 2023 (AEST), departing from Hobart and returning to Hobart. . Standard Underway data is continuously recorded, consisting of: (1) Navigation data (NAV): Latitude, Longitude, Speed, Heading, Course Over Ground, Gyros, and Doppler Log (dual GPS instrument). (2) Thermosalinograph (TSG): Water Salinity, Flow-Rate, Temperature, Fluorescence, pCO2 and Optode/Oxygen. (3) Atmospheric (MET): Humidity, Wind Speed and Direction (vane and ultrasonic), Radiometer/Sea Surface Temperature, Pyranometer/Solar Radiation, Photosynthetically Active Radiation (PAR), Air Temperature, Air Pressure, Rain, Ozone and Trace Gases (port and starboard instruments). The quality-controlled RV Investigator underway meteorological and SST data are supplied to the IMOS AODN and other global data repositories and distributors, and made available for satellite SST validation by the Australian Bureau of Meteorology (BoM). Near real-time, unprocessed data are available via the link "Visualisation tool for Underway Data." This dataset has been processed (quality-controlled), and archived by the CSIRO National Collections and Marine Infrastructure (NCMI) Information and Data Centre (IDC). Data are available at time intervals of 5 sec (NetCDF format), 5 sec, 10 sec, 1 min and 5 min (ASCII format). Note: not all variables are quality controlled; please check for existing QC flags in the datasets. Additional information regarding this dataset is contained in the Voyage Summary and/or the Data Processing Reports for this voyage.

This record describes the Acoustic Doppler Current Profiler (ADCP) data collected from the Marine National Facility RV Investigator voyage IN2019_V07, titled: "RAN Hydrographic and Maritime Heritage Surveys." The voyage took place from Hobart (TAS) to Hobart between April 11 and April 23, 2019. Data was collected during IN2019_V07 for parts of the voyage; however, gaps in the data occur at times when multibeam surveys were conducted. Data was collected using UHDAS and post-processed using CODAS. Both the RDI Ocean Surveyor 150kHz ADCP and the RDI Ocean Surveyor 75kHz ADCP were run in narrowband. Internal triggering was used. The drop keel was at 2m below the waterline for most of the voyage. See the voyage computing and electronics report for more details regarding data acquisition. This dataset was processed and then archived within the CSIRO Oceans and Atmosphere (O&A) Information and Data Centre (IDC) in Hobart.

This record describes the Conductivity-Temperature-Depth (CTD) data collected from the Marine National Facility RV Investigator voyage IN2021_V03, titled: "Integrated Marine Observing System: monitoring of East Australian Current property transports at 27o S." The voyage took place between May 8 and June 3, 2021 departing from Hobart (TAS) and arriving in Brisbane (QLD). Data for 36 deployments were acquired using the Sea-Bird SBE911 CTD 24, fitted with 19 twelve litre bottles on the rosette sampler. Sea-Bird-supplied calibration factors were used to compute the pressures and preliminary conductivity values. CSIRO -supplied calibrations were applied to the temperature data. The data were subjected to automated QC to remove spikes and out-of-range values. The final conductivity calibration was based on a single deployment grouping. The final calibration from the primary sensor had a standard deviation (SD) of 0.0019084 PSU, when rounded this is outside our target of ‘better than 0.002 PSU’, so the cut-off was adjusted to 0.003 PSU. The standard product of 1 decibar binned averaged were produced using data from the primary sensors. Cast 10 was ended prematurely so CapPro could not process cast properly. To overcome this, in MATLAB, the end of cast 9 was attached to the end of cast 10. This data will not appear in the raw files from SeaSave and should not affect processing, as CapPro will remove out of water data before processing but needs this data to find the end of the cast. During cast 12 the CTD landed on the bottom of the ocean floor, no damage was found, and all subsequent casts performed as expected. Prior to cast 31, due to some discrepancies between the primary and secondary sensors, the Seagoing Instrumentation Team swapped the secondary pump. This resolved the particular issue. Bottle seven had intermittent problems firing reliably. Initially the release magnet was swapped and all further casts had a backup fired with bottle 7, however it was later found that the root cause was corrosion under the epoxy. As a precaution, the whole trigger mechanism was swapped. The dissolved oxygen data calibration fit had a SD of 0.84461μM. The agreement between the CTD and bottle data was good. PAR, Transmissometer, CDOM, Altimeter and Ecotriplet were also installed on the auxiliary A/D channels of the CTD. The collected data were subsequently processed and archived within the CSIRO National Collections and Marine Infrastructure (NCMI) Information and Data Centre (IDC) in Hobart. Additional information regarding this dataset may be contained in the Voyage Summary and the CTD Data Processing Report.

This record describes Hydrology (HYD) data collected from the Marine National Facility (MNF) RV Investigator voyage Voyage IN2021_T01, titled "Transit Brisbane-Darwin." The voyage took place between June 12 and June 23, 2021 departing from Brisbane (QLD) and arriving in Darwin (NT). . Hydrology samples were collected from Niskin bottles sampled at various depths during Conductivity-Temperature-Depth (CTD) deployments. Parameters analysed were salinity, dissolved oxygen, phosphate, silicate, nitrate plus nitrite and ammonium. This dataset has been archived at the CSIRO National Collections and Marine Infrastructure (NCMI) Information and Data Centre (IDC) in Hobart. Additional information regarding this dataset is contained in the Voyage Report and Data Processing Report.

This record describes the Acoustic Doppler Current Profiler (ADCP) data collected from the Marine National Facility RV Investigator voyage IN2018_V03, titled: "Integrated Marine Observing System: monitoring of East Australian Current property transports at 27oS." The voyage took place between April 19 and May 10, 2018 departing Brisbane (QLD) and returning to Brisbane. Data was collected during in2018_v03 for the entire voyage. Data was collected using UHDAS and post-processed using CODAS. The os150(150kHz) ADCP was not operational during this voyage and was replaced with a wh150(150kHZ). The wh150 was calibrated in the preceding transit. The 75khz ADCP was operated in narrowband mode with 8m bins for the duration of the voyage. Internal triggering was used as external triggering was found to be unstable on previous voyages. The drop keel was at 4m for most of the voyage but raised to 2m during periods of rough weather. Acquisition was stopped and started upon a keel depth change to ensure no data was corrupted. See the voyage computing and electronics report for more details regarding data acquisition. This dataset was processed and then archived within the CSIRO Oceans and Atmosphere (O&A) Information and Data Centre (IDC) in Hobart.