Map of the known geothermal resource areas from the California Department of Conservation, CalGEM 2002.

Map of the known geothermal resource areas from the California Department of Conservation, CalGEM 2002.

,This data layer contains geothermal resource areas and their technical potential used in long-term electric system modeling for Integrated Resource Planning and SB 100. Geothermal resource areas are delineated by Known Geothermal Resource Areas (KGRAs) (Geothermal Map of California, 2002), other geothermal fields (CalGEM Field Admin Boundaries, 2020), and Bureau of Land Management (BLM) Geothermal Leasing Areas (California BLM State Office GIS Department, 2010). The fields that are considered in our assessment have enough information known about the geothermal reservoir that an electric generation potential was estimated by USGS (Williams et al. 2008) or estimated by a BLM Environmental Impact Statement (El Centro Field Office, 2007). For the USGS identified geothermal systems, any point that lies within 2 km of a field is summed to represent the total mean electrical generation potential from the entire field.,Geothermal field boundaries are constructed for identified geothermal systems that lie outside of an established geothermal field. A circular footprint is assumed with a radius determined by the area needed to support the mean resource potential estimate, assuming a 10 MW/km2 power density.,Several geothermal fields have power plants that are currently generating electricity from the geothermal source. The total production for each geothermal field is estimated by the CA Energy Commission’s Quarterly Fuel and Energy Report that tracks all power plants greater than 1 MW. The nameplate capacity of all generators in operation as of 2021 were used to inform how much of the geothermal fields are currently in use. This source yields inconsistent results for the power plants in the Geysers. Instead, an estimate from the net energy generation from those power plants is used. Using these estimates, the net undeveloped geothermal resource potential can be calculated.,Finally, we apply the protected area layer for geothermal to screen out those geothermal fields that lie entirely within a protected area. The protected area layer is compiled from public and private lands that have special designations prohibiting or not aligning with energy development.,This layer is featured in the CEC 2023 Land-Use Screens for Electric System Planning data viewer.,For more information about this layer and its use in electric system planning, please refer to the Land Use Screens Staff Report in the CEC Energy Planning Library.,Change Log:,Version 1.1 (January 18, 2024),,,,Data Dictionary:,Total_MWe_Mean: The estimated resource potential from each geothermal field. All geothermal fields, except for Truckhaven, was given an estimate by Williams et al. 2008. If more than one point resource intersects (within 2km of) the field, the sum of the individual geothermal systems was used to estimate the magnitude of the resource coming from the entire geothermal field. Estimates are given in MW.,Total_QFER_NameplateCapacity: The total nameplate capacities of all generators in operation as of 2021 that intersects (within 2 km of) a geothermal field. The resource potential already in use for the Geysers is determined by Lovekin et al. 2004. Estimates are given in MW.,ProtectedArea_Exclusion: Binary value representing whether a field is excluded by the land-use screen or not. Fields that are excluded have a value of 1; those that aren’t have a value of 0.,NetUndevelopedRP: The net undeveloped resource potential for each geothermal field. This field is determined by subtracting the total resource potential in use (Total_QFER_NameplateCapacity) from the total estimated resource potential (Total_MWe_Mean). Estimates are given in MW.,Acres_GeothermalField: This is the geodesic acreage of each geothermal field. Values are reported in International Acres using a NAD 1983 California (Teale) Albers (Meters) projection.,,References:,,

,This data layer contains geothermal resource areas and their technical potential used in long-term electric system modeling for Integrated Resource Planning and SB 100. Geothermal resource areas are delineated by Known Geothermal Resource Areas (KGRAs) (Geothermal Map of California, 2002), other geothermal fields (CalGEM Field Admin Boundaries, 2020), and Bureau of Land Management (BLM) Geothermal Leasing Areas (California BLM State Office GIS Department, 2010). The fields that are considered in our assessment have enough information known about the geothermal reservoir that an electric generation potential was estimated by USGS (Williams et al. 2008) or estimated by a BLM Environmental Impact Statement (El Centro Field Office, 2007). For the USGS identified geothermal systems, any point that lies within 2 km of a field is summed to represent the total mean electrical generation potential from the entire field.,Geothermal field boundaries are constructed for identified geothermal systems that lie outside of an established geothermal field. A circular footprint is assumed with a radius determined by the area needed to support the mean resource potential estimate, assuming a 10 MW/km2 power density.,Several geothermal fields have power plants that are currently generating electricity from the geothermal source. The total production for each geothermal field is estimated by the CA Energy Commission’s Quarterly Fuel and Energy Report that tracks all power plants greater than 1 MW. The nameplate capacity of all generators in operation as of 2021 were used to inform how much of the geothermal fields are currently in use. This source yields inconsistent results for the power plants in the Geysers. Instead, an estimate from the net energy generation from those power plants is used. Using these estimates, the net undeveloped geothermal resource potential can be calculated.,Finally, we apply the protected area layer for geothermal to screen out those geothermal fields that lie entirely within a protected area. The protected area layer is compiled from public and private lands that have special designations prohibiting or not aligning with energy development.,This layer is featured in the CEC 2023 Land-Use Screens for Electric System Planning data viewer.,For more information about this layer and its use in electric system planning, please refer to the Land Use Screens Staff Report in the CEC Energy Planning Library.,Change Log:,Version 1.1 (January 18, 2024),,,,Data Dictionary:,Total_MWe_Mean: The estimated resource potential from each geothermal field. All geothermal fields, except for Truckhaven, was given an estimate by Williams et al. 2008. If more than one point resource intersects (within 2km of) the field, the sum of the individual geothermal systems was used to estimate the magnitude of the resource coming from the entire geothermal field. Estimates are given in MW.,Total_QFER_NameplateCapacity: The total nameplate capacities of all generators in operation as of 2021 that intersects (within 2 km of) a geothermal field. The resource potential already in use for the Geysers is determined by Lovekin et al. 2004. Estimates are given in MW.,ProtectedArea_Exclusion: Binary value representing whether a field is excluded by the land-use screen or not. Fields that are excluded have a value of 1; those that aren’t have a value of 0.,NetUndevelopedRP: The net undeveloped resource potential for each geothermal field. This field is determined by subtracting the total resource potential in use (Total_QFER_NameplateCapacity) from the total estimated resource potential (Total_MWe_Mean). Estimates are given in MW.,Acres_GeothermalField: This is the geodesic acreage of each geothermal field. Values are reported in International Acres using a NAD 1983 California (Teale) Albers (Meters) projection.,,References:,,

,This data layer contains geothermal resource areas and their technical potential used in long-term electric system modeling for Integrated Resource Planning and SB 100. Geothermal resource areas are delineated by Known Geothermal Resource Areas (KGRAs) (Geothermal Map of California, 2002), other geothermal fields (CalGEM Field Admin Boundaries, 2020), and Bureau of Land Management (BLM) Geothermal Leasing Areas (California BLM State Office GIS Department, 2010). The fields that are considered in our assessment have enough information known about the geothermal reservoir that an electric generation potential was estimated by USGS (Williams et al. 2008) or estimated by a BLM Environmental Impact Statement (El Centro Field Office, 2007). For the USGS identified geothermal systems, any point that lies within 2 km of a field is summed to represent the total mean electrical generation potential from the entire field.,Geothermal field boundaries are constructed for identified geothermal systems that lie outside of an established geothermal field. A circular footprint is assumed with a radius determined by the area needed to support the mean resource potential estimate, assuming a 10 MW/km2 power density.,Several geothermal fields have power plants that are currently generating electricity from the geothermal source. The total production for each geothermal field is estimated by the CA Energy Commission’s Quarterly Fuel and Energy Report that tracks all power plants greater than 1 MW. The nameplate capacity of all generators in operation as of 2021 were used to inform how much of the geothermal fields are currently in use. This source yields inconsistent results for the power plants in the Geysers. Instead, an estimate from the net energy generation from those power plants is used. Using these estimates, the net undeveloped geothermal resource potential can be calculated.,Finally, we apply the protected area layer for geothermal to screen out those geothermal fields that lie entirely within a protected area. The protected area layer is compiled from public and private lands that have special designations prohibiting or not aligning with energy development.,This layer is featured in the CEC 2023 Land-Use Screens for Electric System Planning data viewer.,For more information about this layer and its use in electric system planning, please refer to the Land Use Screens Staff Report in the CEC Energy Planning Library.,Change Log:,Version 1.1 (January 18, 2024),,,,Data Dictionary:,Total_MWe_Mean: The estimated resource potential from each geothermal field. All geothermal fields, except for Truckhaven, was given an estimate by Williams et al. 2008. If more than one point resource intersects (within 2km of) the field, the sum of the individual geothermal systems was used to estimate the magnitude of the resource coming from the entire geothermal field. Estimates are given in MW.,Total_QFER_NameplateCapacity: The total nameplate capacities of all generators in operation as of 2021 that intersects (within 2 km of) a geothermal field. The resource potential already in use for the Geysers is determined by Lovekin et al. 2004. Estimates are given in MW.,ProtectedArea_Exclusion: Binary value representing whether a field is excluded by the land-use screen or not. Fields that are excluded have a value of 1; those that aren’t have a value of 0.,NetUndevelopedRP: The net undeveloped resource potential for each geothermal field. This field is determined by subtracting the total resource potential in use (Total_QFER_NameplateCapacity) from the total estimated resource potential (Total_MWe_Mean). Estimates are given in MW.,Acres_GeothermalField: This is the geodesic acreage of each geothermal field. Values are reported in International Acres using a NAD 1983 California (Teale) Albers (Meters) projection.,,References:,,

Energy generation data and map are from the California Energy Commission. Map depicts commercial geothermal energy generation by county. Unshaded counties had no commercial geothermal energy generation. Data is from 2022 and is current as of May 14, 2024. Projection: NAD 1983 (2011) California (Teale) Albers (Meters). For more information, contact John Hingtgen at 916 510-9747 or Jessica Lin at 415 990-8392.

Energy generation data and map are from the California Energy Commission. Map depicts commercial geothermal energy generation by county. Unshaded counties had no commercial geothermal energy generation. Data is from 2022 and is current as of May 14, 2024. Projection: NAD 1983 (2011) California (Teale) Albers (Meters). For more information, contact John Hingtgen at 916 510-9747 or Jessica Lin at 415 990-8392.

Energy generation data and map are from the California Energy Commission. Map depicts commercial geothermal energy generation by county. Unshaded counties had no commercial geothermal energy generation. Data is from 2022 and is current as of May 14, 2024. Projection: NAD 1983 (2011) California (Teale) Albers (Meters). For more information, contact John Hingtgen at 916 510-9747 or Jessica Lin at 415 990-8392.

Energy generation data and map are from the California Energy Commission. Map depicts commercial geothermal energy generation by county. Unshaded counties had no commercial geothermal energy generation. Data is from 2022 and is current as of May 14, 2024. Projection: NAD 1983 (2011) California (Teale) Albers (Meters). For more information, contact John Hingtgen at 916 510-9747 or Jessica Lin at 415 990-8392.

Energy capacity data and map are from the California Energy Commission. Map depicts geothermal energy capacity by county. Unshaded counties had no commercial geothermal energy capacity. Data is from 2022 and is current as of May 14, 2024. Projection: NAD 1983 (2011) California (Teale) Albers (Meters). For more information, contact John Hingtgen at 916 510-9747 or Jessica Lin at 415 990-8392.