This geospatial data set represents about 2,500 locations of boreholes, shafts, tunnels, and drifts on and around the Nevada Test Site (NTS) where rock-samples have been collected. Information from the rock-samples is summarized for each hole and includes lithologic descriptions, physical and mechanical properties, fracture characteristics, and hydraulic properties where holes were completed below the water table. The digital data are accessed from the webpage for the NTS U.S. Geological Survey (USGS) Core Library and Data Center, Mercury, Nevada. Links to additional information, such as water-level data from the National Water Inventory System (NWIS), and USGS borehole graphical information are included for some holes.

Sediment cores were collected in the Cache Creek Settling Basin (CCSB), Yolo County, California, during October 2011 at 10 locations (borehole sites) and during August 2012 at 5 other locations. Total core depths ranged from approximately 4.6 to 13.7 meters (15 to 45 feet), with penetration to about 9.1 meters (30 feet) at most locations. Detailed subsampling (3-centimeter intervals) was done at total of seven locations: six along an east-west transect in the southern part of the Cache Creek Settling Basin and at one in the northern part of the basin for analyses of total mercury; organic content; and cesium-137, which was used for dating. This data release reports results of the analyses of each subsample of these sediment cores, including associated quality-assurance and quality-control data.

Sediment cores were collected in the Cache Creek Settling Basin (CCSB), Yolo County, California, during October 2011 at 10 locations (borehole sites) and during August 2012 at 5 other locations. Total core depths ranged from approximately 4.6 to 13.7 meters (15 to 45 feet), with penetration to about 9.1 meters (30 feet) at most locations. Detailed subsampling (3-centimeter intervals) was done at total of seven locations: six along an east-west transect in the southern part of the Cache Creek Settling Basin and at one in the northern part of the basin for analyses of total mercury; organic content; and cesium-137, which was used for dating. This data release reports results of the analyses of each subsample of these sediment cores, including associated quality-assurance and quality-control data.

Borehole log number, State Well Number, location, construction information, and any wells tests performed on select wells from the Anza basin, Anza, CA. Also includes a lithologic data for a sub-set of borehole logs identified based on best coverage and representation of data within the study area.

Borehole log number, State Well Number, location, construction information, and any wells tests performed on select wells from the Anza basin, Anza, CA. Also includes a lithologic data for a sub-set of borehole logs identified based on best coverage and representation of data within the study area.

This data release provides borehole location and lithology information from selected boreholes in the East Mesa and surrounding areas of Imperial County, California. The area of focus includes parts of the Imperial, Ogilby, and Amos Valley groundwater basins. The purpose of the study is to estimate the future Total Dissolved Solids (TDS) concentration in groundwater pumped by the LCWPS into the All-American Canal. The borehole data included in this data release can be used to evaluate the hydrogeologic framework of the study area, and determine the geometry, extent, and physical characteristics of hydrogeologic materials within the aquifer system. Borehole location and lithology data were sourced from the California Department of Water Resources Online System of Well Completion Reports (OSWCR; California Department of Water Resources, 2021) as well as direct communication with California Department of Water Resources (California Department of Water Resources, 2024); the U.S. Bureau of Reclamation Final Environmental Impact Statement Geohydrology Appendix for the All-American Canal Lining Project (U.S. Bureau of Reclamation, 1994); well log archives from the U.S. Bureau of Reclamation Yuma Area Office (U.S. Bureau of Reclamation, 2023); the U.S. Geological Survey (USGS) Professional Paper Series number 486 chapter K (Loeltz and others, 1975); a USGS publication detailing the characterization of the groundwater system near the Lower Colorado Water Supply Project (Coes and others, 2015), geothermal well reports (Coplen and others, 1973; Elders and others, 1974), and geothermal wells from California Geologic Energy Management Division (CalGEM; California Department of Conservation, 2024).

This data release provides borehole location and lithology information from selected boreholes in the East Mesa and surrounding areas of Imperial County, California. The area of focus includes parts of the Imperial, Ogilby, and Amos Valley groundwater basins. The purpose of the study is to estimate the future Total Dissolved Solids (TDS) concentration in groundwater pumped by the LCWPS into the All-American Canal. The borehole data included in this data release can be used to evaluate the hydrogeologic framework of the study area, and determine the geometry, extent, and physical characteristics of hydrogeologic materials within the aquifer system. Borehole location and lithology data were sourced from the California Department of Water Resources Online System of Well Completion Reports (OSWCR; California Department of Water Resources, 2021) as well as direct communication with California Department of Water Resources (California Department of Water Resources, 2024); the U.S. Bureau of Reclamation Final Environmental Impact Statement Geohydrology Appendix for the All-American Canal Lining Project (U.S. Bureau of Reclamation, 1994); well log archives from the U.S. Bureau of Reclamation Yuma Area Office (U.S. Bureau of Reclamation, 2023); the U.S. Geological Survey (USGS) Professional Paper Series number 486 chapter K (Loeltz and others, 1975); a USGS publication detailing the characterization of the groundwater system near the Lower Colorado Water Supply Project (Coes and others, 2015), geothermal well reports (Coplen and others, 1973; Elders and others, 1974), and geothermal wells from California Geologic Energy Management Division (CalGEM; California Department of Conservation, 2024).

In 2020, the U.S. Geological Survey (USGS), in cooperation with the U.S. Department of Energy (DOE) for Naval Reactors Laboratory Field Office or Naval Reactors Facility (NRF), drilled and constructed borehole USGS 151 (433846112540701) for stratigraphic framework analyses at the Idaho National Laboratory (INL) near the NRF, located in southeastern Idaho. Borehole USGS 151 was continuously cored from approximately 48 to 1,070 feet below land surface (BLS) and rotary drilled from approximately 1,070 to 1,720 feet BLS. Core drilling was discontinued after 1,070 feet BLS and changed over to straight rotary drilling due to funding constraints and deadlines. The USGS collected select geophysical data, daily drilling notes, and prepared detailed core descriptions for core collected to 1,070 ft BLS, which are included as part of this data release. The USGS Research Drilling Program (RDP) performed the core drilling operations and well construction between June 4, 2020 to September 21, 2020; additionally, the USGS RDP collected geophysical data, single caliper log, that was collected on August 15, 2020. The USGS INL Project Office collected multiple geophysical logs on September 15, 2020. Select geophysical data include natural gamma, caliper, neutron, and gamma-gamma density logs which were examined synergistically with available core material to identify contacts between basalt flows and location and thickness of sediment layers. Additionally, a gyroscopic deviation survey was performed and analyzed to reflect the projected well bore path. Geophysical data were collected using Century™ multi-parameter logging probes and select logs are displayed in well log figures. Geophysical data shown in figure displays include the natural gamma and neutron probe (9055C), caliper probe (9065A), gamma-gamma density probe (0024C), and gyroscopic deviation probe (9095C). With the exception of the caliper log, all geophysical data were collected through drill pipe after reaching total depth. Geophysical log data not represented in figure displays can be obtained by downloading attached LAS files. Drill core was taken to the USGS Lithologic Core Storage Library for storage and permanent archive located at Central Facilities Area on the INL. Drill core was photographed and described using standardized methods (Johnson and others, 2005). These standardized methods make use of commercially available software that include using a procedure developed by the USGS INL Project Office. The standardized method maximizes description and minimizes interpretation.

In 2020, the U.S. Geological Survey (USGS), in cooperation with the U.S. Department of Energy (DOE) for Naval Reactors Laboratory Field Office or Naval Reactors Facility (NRF), drilled and constructed borehole USGS 151 (433846112540701) for stratigraphic framework analyses at the Idaho National Laboratory (INL) near the NRF, located in southeastern Idaho. Borehole USGS 151 was continuously cored from approximately 48 to 1,070 feet below land surface (BLS) and rotary drilled from approximately 1,070 to 1,720 feet BLS. Core drilling was discontinued after 1,070 feet BLS and changed over to straight rotary drilling due to funding constraints and deadlines. The USGS collected select geophysical data, daily drilling notes, and prepared detailed core descriptions for core collected to 1,070 ft BLS, which are included as part of this data release. The USGS Research Drilling Program (RDP) performed the core drilling operations and well construction between June 4, 2020 to September 21, 2020; additionally, the USGS RDP collected geophysical data, single caliper log, that was collected on August 15, 2020. The USGS INL Project Office collected multiple geophysical logs on September 15, 2020. Select geophysical data include natural gamma, caliper, neutron, and gamma-gamma density logs which were examined synergistically with available core material to identify contacts between basalt flows and location and thickness of sediment layers. Additionally, a gyroscopic deviation survey was performed and analyzed to reflect the projected well bore path. Geophysical data were collected using Century™ multi-parameter logging probes and select logs are displayed in well log figures. Geophysical data shown in figure displays include the natural gamma and neutron probe (9055C), caliper probe (9065A), gamma-gamma density probe (0024C), and gyroscopic deviation probe (9095C). With the exception of the caliper log, all geophysical data were collected through drill pipe after reaching total depth. Geophysical log data not represented in figure displays can be obtained by downloading attached LAS files. Drill core was taken to the USGS Lithologic Core Storage Library for storage and permanent archive located at Central Facilities Area on the INL. Drill core was photographed and described using standardized methods (Johnson and others, 2005). These standardized methods make use of commercially available software that include using a procedure developed by the USGS INL Project Office. The standardized method maximizes description and minimizes interpretation.