The MMR Calibration Data Set contains radiance data collected in the summer of 1987 and in July and August of 1989 via a Modular Multiband Radiometer (MMR) instrument. The MMR instrument monitored a nearly lambertian calibration panel stationed near the center of the FIFE study area. The radiances recorded from this instrument can be used to monitor solar insolation and clouds. In some cases, these data were also used to calculate the reflectance factor for reflective radiances measured over vegetation using other MMR instruments located at other FIFE sites or mounted on a helicopter.

Surface reflectance factors, radiances, and temperatures were measured with a Mast-borne Modular Multiband Radiometer (MMR), predominantly in the solar principal plane, with nadir and off-nadir, view-zenith angles. The MMR was mounted on a portable mast in order to achieve a spatial sampling at a variety of sites as well as within each site. The portable mast alignment varied from the solar principal plane, to the azimuthal plane aligned perpendicular to the principal plane and aligned with the satellite azimuthal plane. Measurements were periodically collected with the MMR over a barium sulfate reference panel. Measurements were typically coordinated with aircraft and/or satellite overpasses. Solar radiation data at or near the specific site should be used to screen possible times of variable cloud cover.

Ground based spectral reflectance in MSS bands 1-4 from Exotech model 100-A

Contains site averaged reflected radiance and reflectance values from barnes MMR taken from helicopter.

Site averaged reflected radiance & reflectance from Barnes MMR from helicopter

Field sunphotometer data collected on 8/13-15/90 used to provide quantitative atmospheric correction to remotely sensed data of forest reflectance and radiance

Canopy IR & air temperature, albedo, incoming and reflected shortwave, humidity

Site specifice radiance, exoatmospheric reflectance & surface reflectance

The Surface Reflectance Measured with a Helicopter-borne MMR Data Set contains surface reflectance measurements in Landsat-TM bands at low to intermediate altitudes. The helicopter operated during all Intensive Field Campaigns (IFCs) and was available to support all satellite overpasses. The average flight time was 2 hours, during which an average of 11 FIFE sites plus one special target were covered. The helicopter missions were designed to provide a rapid means of intensively spectrally characterizing each FIFE site while providing FIFE study area coverage, and to provide an intermediate scale of sampling between that of the surface measurements and the higher altitude aircraft and spacecraft multispectral imaging devices. The Modular Multiband Radiometer (MMR) instrumentation was chosen to provide compatibility with surface-based radiometers and TM spacecraft sensors. Off-nadir measurements were made as a means of providing more accurate estimates of hemispherical reflectance and for use with bi-directional reflectance models.

This data set includes solar surface irradiance from Kipp and Zonen CM-21 pyranometers, both total unfiltered and filtered (RG695), and photosynthetically active radiation (PAR) from Skye-Probetech SKE-510 PAR sensors. Measurements were made at six sites acrosss the Brazilian Amazon during the period from 1999 to 2004. These sites were co-located with AERONET (AErosol RObotic NETwork) program sites. There are 17 comma-delimited data files (.csv) with this data set. The AERONET program is an inclusive federation of ground-based remote sensing aerosol networks established by AERONET and the PHOtometrie pour le Traitement Operationnel de Normalisation Satellitaire (PHOTONS) and greatly expanded by AEROCAN (the Canadian sunphotometer network) and other agency, institute and university partners. The goal is to assess aerosol optical properties and validate satellite retrievals of those properties. The network imposes standardization of instruments, calibration, and processing.