This submission contains several ArcGIS shapefiles, each with Temperature contour lines at different depths. Subsurface temperature were important for characterizing the geothermal system beneath the FORGE site in Milford, Utah.

This submission contains a cumulative record of one-dimensional temperature modeling based off of well data in the vicinity of the Utah FORGE site. Temperature log data from wells used, and in some cases were extrapolated below the bottom of a number of wells. The data were corrected for elevation and location using the Utah FORGE earth model. These data locations correspond to well locations provided in GDR Submission 1111 (linked below). All data are georeferenced to UTM, zone 12N, NAD 83, NAVD 88.

This is a GIS point feature shapefile representing wells, and their temperatures, that are located in the general Utah FORGE area near Milford, Utah. There are also fields that represent interpolated temperature values at depths of 200 m, 1000 m, 2000 m, 3000 m, and 4000 m. in degrees Fahrenheit. The temperature values at specific depths as mentioned above were derived as follows. In cases where the well reached a given depth (200 m and 1, 2, 3, or 4 km), the temperature is the measured temperature. For the shallower wells (and at deeper depths in the wells reaching one or more of the target depths), temperatures were extrapolated from the temperature-depth profiles that appeared to have stable (re-equilibrated after drilling) and linear profiles within the conductive regime (i.e. below the water table or other convective influences such as shallow hydrothermal outflow from the Roosevelt Hydrothermal System). Measured temperatures/gradients from deeper wells (when available and reasonably close to a given well) were used to help constrain the extrapolation to greater depths. Most of the field names in the attribute table are intuitive, however HF = heat flow, intercept = the temperature at the surface (x-axis of the temperature-depth plots) based on the linear segment of the plot that was used to extrapolate the temperature profiles to greater depths, and depth_m is the total well depth. This information is also present in the shapefile metadata.

This archive contains a terrain slope image, in units of degrees, of the Utah FORGE area near Roosevelt Hot springs. The data was derived from 0.5 m resolution LiDAR DEM data and is in a GeoTiff format. It was processed using ArcGIS.

This submission includes two modeled drawdown scenarios with new supply well locations, a total dissolved solids (TDS) concentration grid (raster dataset representing the spatial distribution of TDS), and an excel spreadsheet containing well data.

This is a temperature gradient database for Utah, USA. It is located at the Utah Geological Survey. This contains data relevant to the Utah FORGE project.

This submission contains a number of data files with vertices of meshed/interpolated surfaces used in the Phase 2B earth model. Examples include land surface (based on 10-meter DEM), the granitoid-basin fill contact, several faults, and also interpolated temperature isosurfaces for 175 and 225 degrees C. All data are georeferenced to UTM, zone 12N, NAD 83, NAVD 88.

This archive contains a GIS point feature shapefile that shows the locations of wells in the general region of the Utah FORGE project, near Roosevelt Hot Springs. This includes Utah FORGE deep well 58-32 and wells for which data has been uploaded to the Geothermal Data Repository. The attribute table has a field that contains well names.

This archive contains temperature data for Roosevelt Hot Springs observation wells OH-1, OH-4, OH-5 and OH-7. There are also mud logs for OH-4. These are old datasets obtained from Rocky Mountain Power for use in the Utah FORGE project. Temperature data were collected in the 1970s and 1980s.

This archive contains a geology map of the general Roosevelt Hot Springs region, both in PDF and ArcGIS geodatabase formats, that was created as part of the Utah FORGE project.