RV Investigator Voyage IN2018 V02 CTD Data
공공데이터포털
This record describes the Conductivity-Temperature-Depth (CTD) data collected from the Marine National Facility RV Investigator voyage IN2018_V02, titled: "SOTS: Southern Ocean Time Series automated moorings for climate and carbon cycle studies south west Tasmania; Subantarctic Biogeochemistry of Carbon and Iron." The voyage took place between March 3 and March 21, 2018 departing from Hobart (TAS) and arriving in Hobart. Data for 7 deployments were acquired using the Seabird SBE911 CTD unit 24, fitted with 36 twelve litre bottles on the rosette sampler. Samples were collected on casts 2-6. Sea-Bird-supplied calibration factors were used to compute the pressures and preliminary conductivity values. CSIRO -supplied calibrations were applied to the temperature data. The data were subjected to automated QC to remove spikes and out-of-range values. The final conductivity calibration for each deployment was calculated using the sensors with the lowest residuals when compared with the values measured by the hydrochemistry team. The final calibration from chosen sensors all had a standard deviation (S.D) less than our target of ‘better than 0.002 PSU’. The standard product of 1dbar binned averaged were produced using data from the primary conductivity and temperature sensors and the secondary oxygen sensor. The dissolved oxygen data calibration generally showed a good agreement between the CTD and bottle data. A Biospherical photosynthetically active radiation (PAR), Wetlabs transmissometer, Chelsea fluorometer and the Wetlabs ECO chlorophyll and Eco-scattering sensors were also installed on the auxiliary A/D channels of the CTD. An IMU and LADCP unit was also attached to the rosette for all casts. The collected data were subsequently processed and archived within the CSIRO Oceans and Atmosphere (O&A) Information and Data Centre (IDC) in Hobart. Additional information regarding this dataset may be contained in the Voyage Summary and the CTD Data Processing Report.
RV Investigator Voyage IN2018 V02 SBP120 Sub-bottom Profiler Data
공공데이터포털
This record describes sub bottom profiler data collected on RV Investigator voyage IN2018_V02 , "SOTS: Southern Ocean Time Series automated moorings for climate and carbon cycle studies southwest of Tasmania" and "Subantarctic Biogeochemistry of Carbon and Iron, Southern Ocean Time Series site" which departed Hobart on the 03 March 2018 and returned to Hobart briefly on 12 March and finally concluded on the 21 March 2018 in Hobart. Unfortunately a hardware error caused the instrument to be turned off from 5 March 2018. The Kongsberg SBP120 (sub bottom profiler) was used to acquire data containing the specular reflections at different sediment interfaces below the seafloor. The SBP120 provides a 3° by 3° angular resolution. The echosounder's frequency sweep range is from 2.5 to 7 kHz. The SBP120 was logged sporadically for the extent of the voyage. Data are stored in .raw (23 files 2.43 GB) raw and .seg (27 files 2.41 GB) segy formats at CSIRO. The segy format data had a real time processing stream applied, which applies gain, a gain correction, matched filter with replica shaping, an attribute calculation for instantaneous amplitude and time variable gain. Additional information regarding this dataset is contained in the GSM data acquisition and processing report. Additional data products may be available on request
RV Investigator Voyage IN2018 V02 EK60 Echosounder
공공데이터포털
This record describes scientific split-beam echosounder data collected on the RV Investigator voyage IN2018_V02, "SOTS: Southern Ocean Time Series automated moorings for climate and carbon cycle studies southwest of Tasmania" and "Subantarctic Biogeochemistry of Carbon and Iron, Southern Ocean Time Series site" which departed Hobart on the 03 March 2018 and returned to Hobart briefly on 12 March and finally concluded on the 21 March 2018. The Simrad EK60 split beam echosounders, 18, 38, 70 120, 200 and 333 kHz were used to acquire acoustic backscatter data. The settings and monitoring were undertaken as part of a piggy back project, by Rudy Kloser, "Acoustic zooplankton and fish" . Data are stored in .raw, .bot and *.idx format at CSIRO. There are 3460 files totalling 65.6 GB of data in this dataset. Additional information regarding this dataset is contained in the GSM data acquisition and processing report. Additional data products may be available on request.
RV Investigator Voyage IN2018 V02 Underway UWY Data
공공데이터포털
This record describes the Underway (UWY) data collected from the Marine National Facility (MNF) RV Investigator Voyage IN2018_V02, titled: "SOTS: Southern Ocean Time Series automated moorings for climate and carbon cycle studies southwest of Tasmania; Subantarctic Biogeochemistry of Carbon and Iron, Southern Ocean Time Series site." The voyage took place between March 3 and March 20, 2018 departing from Hobart (TAS) and arriving in Hobart. Standard Underway data is continuously recorded, consisting of: (1) Navigation data (NAV): Latitude, Longitude, Speed, Heading, Course Over Ground, Gyros, and Doppler Log (dual GPS instrument). (2) Thermosalinograph (TSG): Water Salinity, Flow-Rate, Temperature, Fluorescence, pCO2 and Optode/Oxygen. (3) Atmospheric (MET): Humidity, Wind Speed and Direction (vane and ultrasonic), Radiometer/Sea Surface Temprature, Pyranometer/Solar Radiation, Photosynthetically Active Radiation (PAR), Air Temperature, Air Pressure, Rain, Ozone and Trace Gases (port and starboard instruments). Data are recorded at 5 second intervals. Near real-time data are available via the link "Visualisation tool for Underway Data." This dataset will be processed and archived within the CSIRO Oceans & Atmosphere (O&A) Information and Data Centre (IDC) in Hobart (TAS). Data are available at time intervals of 5 sec (NetCDF format), 10 sec and 5 min (ASCII format). Additional information regarding this dataset is contained in the Voyage Summary and/or the Data Processing Report for this voyage.
RV Investigator Voyage IN2018 V02 EM710 MKII Multibeam Echosounder Data
공공데이터포털
This record describes multibeam echosounder data collected on RV Investigator voyage IN2018_V02 ,”SOTS: Southern Ocean Time Series automated moorings for climate and carbon cycle studies southwest of Tasmania" and "Subantarctic Biogeochemistry of Carbon and Iron, Southern Ocean Time Series site" which departed Hobart on the 03 March 2018 and returned to Hobart briefly on 12 March and finally concluded on the 21 March 2018. The Kongsberg EM710 MKII multibeam echosounder was used to acquire seafloor bathymetry and backscatter information in shallow water during transits. The EM710 MKII provides a 0.5° by 1° transmit and receive angular resolution respectively. The echosounder's nominal frequency range is from 40 to 100 kHz. Data are stored in .all raw format for bathymetry and backscatter and .wcd format for watercolumn backscatter at CSIRO. There are 39 files totalling 5.93 GB of raw data in this dataset. Sound velocity profiles were applied to this data during data acquisition. Bathymetry data contained in *.all format are corrected for motion and position. Tide corrections were not applied to the processed data. Processed data has had outliers removed. Processed line data are available in *.gsf and ascii format, and processed bathymetry grid in geotiff format. Additional information regarding this dataset, including further information on processing streams, is contained in the GSM data acquisition and processing report. Additional data products may be available on request.
RV Investigator Voyage IN2019 V02 Underway UWY Data
공공데이터포털
This record describes the Underway (UWY) data collected from the Marine National Facility (MNF) RV Investigator Voyage IN2019_V02, titled: "SOTS: Southern Ocean Time Series automated moorings for climate and carbon cycle studies southwest of Tasmania; Subantarctic Biogeochemistry of Carbon and Iron, Southern Ocean Time Series site." The voyage took place between March 14 and April 5, 2019 departing from Hobart (TAS) and arriving in Hobart. Standard Underway data is continuously recorded, consisting of: (1) Navigation data (NAV): Latitude, Longitude, Speed, Heading, Course Over Ground, Gyros, and Doppler Log (dual GPS instrument). (2) Thermosalinograph (TSG): Water Salinity, Flow-Rate, Temperature, Fluorescence, pCO2 and Optode/Oxygen. (3) Atmospheric (MET): Humidity, Wind Speed and Direction (vane and ultrasonic), Radiometer/Sea Surface Temperature, Pyranometer/Solar Radiation, Photosynthetically Active Radiation (PAR), Air Temperature, Air Pressure, Rain, Ozone and Trace Gases (port and starboard instruments). The quality-controlled RV Investigator underway meteorological and SST data are supplied to the IMOS AODN where they are publicly available at the "Ships of Opportunity" Thredds server (http://thredds.aodn.org.au/thredds/catalog/IMOS/SOOP/SOOP-ASF/VLMJ_Investigator/catalog.html) for research. From there, they are downloaded by NOAA for their In Situ Quality Monitoring web site (iQUAM2) and made available for satellite SST validation. The SBE 38 SST data are used within the Australian Bureau of Meteorology for real-time satellite SST validation and ingested into real-time SST analyses which are then used as the boundary condition for Numerical Weather Prediction models. The meteorological and SST data are uploaded onto the Global Telecommunications System (GTS) for global dissemination to Meteorological Agencies, and separately supplied to the SAMOS (http://samos.coaps.fsu.edu/html/) Project for air-sea flux research. The real-time SBE 38 SST data are currently (2017) used in the following data products (accessed via the GTS): • International Comprehensive Ocean-Atmosphere Data Set (ICOADS R3.0) (http://icoads.noaa.gov/) • NOAA NCEI Extended Reconstructed Sea Surface Temperature version 4 (ERSST.v4) (https://www.ncdc.noaa.gov/data-access/marineocean-data/extended-reconstructed-sea-surface-temperature-ersst-v4) • Hadley Centre SST Data Set (HadSST3) (http://www.metoffice.gov.uk/hadobs/hadsst3/) • Global Ocean Surface Underway Data (GOSUD) Project (http://www.gosud.org/) • Bureau of Meteorology daily and weekly SST analyses (http://www.bom.gov.au/marine/sst.shtml) • NOAA NCEI “Reynolds” daily global OISST analysis (https://www.ncdc.noaa.gov/oisst) • NASA JPL “MUR” 1 km daily global SST analysis (https://mur.jpl.nasa.gov/) • UK Met Office “OSTIA” daily global SST analysis (http://ghrsst-pp.metoffice.com/pages/latest_analysis/ostia.html) • CMC daily global SST analysis • Ourocean “G1SST” global daily 1 km SST analysis (https://ourocean.jpl.nasa.gov/SST) As part of the underway data gathering system, other datasets are produced (e.g., pCO2, ISAR SST) which are processed separately and have their own metadata records. Data are recorded at 5 second intervals. Near real-time data are available via the link "Visualisation tool for Underway Data." This dataset will be processed and archived within the CSIRO Oceans & Atmosphere (O&A) Information and Data Centre (IDC) in Hobart (TAS). Data are available at time intervals of 5 sec (NetCDF format), 10 sec and 5 min (ASCII format). Additional information regarding this dataset is contained in the Voyage Summary and/or the Data Processing Report for this voyage.