This data set consists of digitized aquifer boundaries for the Vamoosa-Ada aquifer in east-central Oklahoma. The Vamoosa-Ada aquifer is an important source of water that underlies about 2,320-square miles of parts of Osage, Pawnee, Payne, Creek, Lincoln, Okfuskee, and Seminole Counties. Approximately 75 percent of the water withdrawn from the Vamoosa-Ada aquifer is for municipal use. Rural domestic use and water for stock animals account for most of the remaining water withdrawn. The Vamoosa-Ada aquifer is defined in a ground-water report as consisting principally of the rocks of the Late Pennsylvanian-age Vamoosa Formation and overlying Ada Group. The Vamoosa-Ada aquifer consists of a complex sequence of fine- to very fine-grained sandstone, siltstone, shale, and conglomerate interbedded with very thin limestones. The water-yielding capabilities of the aquifer are generally controlled by lateral and vertical distribution of the sandstone beds and their physical characteristics. The Vamoosa-Ada aquifer is unconfined where it outcrops in about an 1,700-square-mile area. Most of the aquifer boundary lines were extracted from published digital geology data sets. The lines in the digital geology data sets were scanned or digitized from maps published at a scale of 1:250,000 and represent geologic contacts. Some of the aquifer boundary lines were interpolated in areas where the Vamoosa-Ada aquifer is overlain by alluvial and terrace deposits near streams and rivers.

This data set consists of digitized polygons of constant hydraulic conductivity values for the Vamoosa-Ada aquifer in east-central Oklahoma. The Vamoosa-Ada aquifer is an important source of water that underlies about 2,320-square miles of parts of Osage, Pawnee, Payne, Creek, Lincoln, Okfuskee, and Seminole Counties. Approximately 75 percent of the water withdrawn from the Vamoosa-Ada aquifer is for municipal use. Rural domestic use and water for stock animals account for most of the remaining water withdrawn. The Vamoosa-Ada aquifer is defined in a ground-water report as consisting principally of the rocks of the Late Pennsylvanian-age Vamoosa Formation and overlying Ada Group. The Vamoosa-Ada aquifer consists of a complex sequence of fine- to very fine-grained sandstone, siltstone, shale, and conglomerate interbedded with very thin limestones. The water-yielding capabilities of the aquifer are generally controlled by lateral and vertical distribution of the sandstone beds and their physical characteristics. The Vamoosa-Ada aquifer is unconfined where it outcrops in about an 1,700-square-mile area. The hydraulic conductivity of the Vamoosa-Ada aquifer was computed as 3 feet per day in a ground-water report. Most of the hydraulic conductivity polygons were extracted from published digital geology data sets. The lines in the digital geology data sets were scanned or digitized from maps published at a scale of 1:250,000 and represent geologic contacts. Some of the lines in the data set were interpolated in areas where the Vamoosa-Ada aquifer is overlain by alluvial and terrace deposits near streams and rivers.

This data set consists of digitized polygons of constant hydraulic conductivity values for the Vamoosa-Ada aquifer in east-central Oklahoma. The Vamoosa-Ada aquifer is an important source of water that underlies about 2,320-square miles of parts of Osage, Pawnee, Payne, Creek, Lincoln, Okfuskee, and Seminole Counties. Approximately 75 percent of the water withdrawn from the Vamoosa-Ada aquifer is for municipal use. Rural domestic use and water for stock animals account for most of the remaining water withdrawn. The Vamoosa-Ada aquifer is defined in a ground-water report as consisting principally of the rocks of the Late Pennsylvanian-age Vamoosa Formation and overlying Ada Group. The Vamoosa-Ada aquifer consists of a complex sequence of fine- to very fine-grained sandstone, siltstone, shale, and conglomerate interbedded with very thin limestones. The water-yielding capabilities of the aquifer are generally controlled by lateral and vertical distribution of the sandstone beds and their physical characteristics. The Vamoosa-Ada aquifer is unconfined where it outcrops in about an 1,700-square-mile area. The hydraulic conductivity of the Vamoosa-Ada aquifer was computed as 3 feet per day in a ground-water report. Most of the hydraulic conductivity polygons were extracted from published digital geology data sets. The lines in the digital geology data sets were scanned or digitized from maps published at a scale of 1:250,000 and represent geologic contacts. Some of the lines in the data set were interpolated in areas where the Vamoosa-Ada aquifer is overlain by alluvial and terrace deposits near streams and rivers.

This data set consists of digitized water-level elevation contours for the High Plains aquifer in western Oklahoma. This area encompasses the panhandle counties of Cimarron, Texas, and Beaver, and the western counties of Harper, Ellis, Woodward, Dewey, and Roger Mills. The High Plains aquifer underlies approximately 7,000 square miles of Oklahoma and is used extensively for irrigation. The High Plains aquifer is a water-table aquifer and consists predominately of the Tertiary-age Ogallala Formation and overlying Quaternary-age alluvial and terrace deposits. In some areas the aquifer is absent and the underlying Triassic, Jurassic, or Cretaceous-age rocks are exposed at the surface. These rocks are hydraulically connected with the aquifer in some areas. The High Plains aquifer is composed of interbedded sand, siltstone, clay, gravel, thin limestones, and caliche. The proportion of various lithological materials changes rapidly from place to place, but poorly sorted sand and gravel predominate. The rocks are poorly to moderately well cemented by calcium carbonate. The water-level elevations were measured in January, February, and March 1980 and ranged from about 4,650 feet above sea level in Cimarron County to about 2,000 feet above sea level in Woodward County. The water-level elevation contours were digitized from folded paper maps in a published report. The source maps were published at a scale of 1:250,000.

This data set consists of digitized water-level elevation contours for the Central Oklahoma aquifer in central Oklahoma. This area encompasses all or part of Cleveland, Lincoln, Logan, Oklahoma, Payne, and Pottawatomie Counties. The Central Oklahoma aquifer includes the alluvial and terrace deposits along major streams, the Garber Sandstone and Wellington Formations, and the Chase, Council Grove, and Admire Groups. The Quaternary-age alluvial and terrace deposits consist of unconsolidated clay, silt, sand, and gravel. The Permian-age Garber Sandstone and Wellington Formations consist of sandstone with interbedded siltstone and mudstone. The Permian-age Chase, Council Grove, and Admire Groups consist of sandstone, shale, and thin limestone. The Central Oklahoma aquifer underlies about 3,000 square miles of central Oklahoma where the aquifer is used extensively for municipal, industrial, commercial, and domestic water supplies. Most of the usable ground water within the aquifer is from the Garber Sandstone and Wellington Formations. Substantial quantities of usable ground water also are present in the Chase, Council Grove, and Admire Groups, and in alluvial and terrace deposits associated with the major streams. The water-level elevation map was created from digital data sets developed to produce a map for a previously published report. Water-levels measured in wells during the winter of 1986 and 1987 were used to construct the map. The digital data set contains water-level elevations that range from 850 to 1,350 feet above sea level or the National Geodetic Vertical Datum of 1929 (NGVD29).

This data set consists of digital aquifer boundaries for the High Plains aquifer in western Oklahoma. This area encompasses the panhandle counties of Cimarron, Texas, and Beaver, and the western counties of Harper, Ellis, Woodward, Dewey, and Roger Mills. The High Plains aquifer underlies approximately 7,000 square miles of Oklahoma and is used extensively for irrigation. The High Plains aquifer is a water-table aquifer and consists predominately of the Tertiary-age Ogallala Formation and overlying Quaternary-age alluvial and terrace deposits. In some areas the aquifer is absent and the underlying Triassic, Jurassic, or Cretaceous-age rocks are exposed at the surface. These rocks are hydraulically connected with the aquifer in some areas. The High Plains aquifer is composed of interbedded sand, siltstone, clay, gravel, thin limestones, and caliche. The proportion of various lithological materials changes rapidly from place to place, but poorly sorted sand and gravel predominate. The rocks are poorly to moderately well cemented by calcium carbonate. The aquifer boundaries were constructed by extracting lines from digital surficial geology data sets based on a scale of 1:125,000 for the panhandle counties and 1:250,000 for the western counties. Some of the lines were digitized from maps in a published water-level elevation map for 1980.