Light Detection and Ranging (LiDAR) data is remotely sensed high-resolution elevation data collected by an airborne collection platform. This LiDAR dataset is a survey of Coastal California. The project area consists of approximately 2616 square miles. The project design of the LiDAR data acquisition was developed to support a nominal post spacing of 1 meter. Fugro EarthData, Inc. acquired 1546 flight lines in 108 lifts between October 2009 and August 2011. This collection was a joint effort by the NOAA Office for Coastal Management (OCM); the California State Coastal Conservancy (SCC) Ocean Protection Council (OPC); Scripps Institution of Oceanography; and the Joint Airborne Lidar Bathymetry Technical Center of Expertise (JALBTCX). The data coverage extends landward 500 m from the shoreline, along the entire California coastline. The data collection was performed with two Piper Navajo twin engine aircrafts, utilizing a Leica ALS60 MPiA sensor; collecting multiple return x, y, and z as well as intensity data. The data were classified as Unclassified (1), Ground (2), Low Point (Noise) (7), Water (9), Mudflats (10), and 12 (Overlap). Only the Unclassified (1), Ground (2), Water (9), and Overlap (12) points are available for download from the NOAA OCM Digital Coast. Original contact information: Contact Org: NOAA Office for Coastal Management Phone: 843-740-1202 Email: coastal.info@noaa.gov

This metadata document describes the collection and processing of Light Detection and Ranging (LIDAR) data over an area along the coast of Saginaw Bay, Lake Huron, Michigan. Data was collected at a nominal two (2) meter post spacing between points. Two elevation data sets were compiled in this project, first surface returns, in which features that are above the ground, such as buildings, bridges, tree tops, etc. have not been eliminated and a Bare Earth Data set. Original contact information: Contact Org: NOAA Office for Coastal Management Phone: 843-740-1202 Email: coastal.info@noaa.gov

Between January and March 2010, lidar data was collected in southeast/coastal Georgia under a multi-agency partnership between the Coastal Georgia Regional Development Center, USGS, FEMA, NOAA and local county governments. Data acquisition is for the full extent of coastal Georgia, approximately 50 miles inland, excluding counties with existing high-resolution lidar derived elevation data. The data capture area consists of an area of approximately 5703 square miles. This project is within the Atlantic Coastal Priority Area as defined by the National Geospatial Program (NGP) and supports homeland security requirements of the National Geospatial-Intelligence Agency (NGA). This project also supports the National Spatial Data Infrastructure (NSDI) and will advance USGS efforts related to The National Map and the National Elevation Dataset. The data were delivered in LAS format version 1.2 in 5000 x 5000 foot tiles. The data are classified according to ASPRS LAS 1.2 classification scheme: Class 1 - Unclassified Class 2 - Bare Earth Class 7 - Low Point (Noise) Class 9 - Water Class 10 - Land below sea level Class 12 - Overlap

The data were acquired in March 2005 using the NASA Experimental Advanced Airborne Research Lidar (EAARL) platform in Sussex County, Delaware. Once acquired, the data were processed by USGS personnel into both 2-foot contours and digital elevation models. Multiple returns were recorded for each laser pulse. This is a bare earth data set. The points have approximately a 3 m ground spacing. Water points remain in the bare earth data set, they have not been classified as water. Original contact information: Contact Org: Delaware Geological Survey Phone: 302-831-2833 Email: delgeosurvey@udel.edu

These data were collected by the National Oceanic Atmospheric Administration National Geodetic Survey Remote Sensing Division using an OPTECH ALTM system. The data includes topographic data in an LAS format file. Original contact information: Contact Org: National Oceanic and Atmospheric Administration (NOAA), National Ocean Service (NOS), National Geodetic Survey (NGS), Remote Sensing Division Title: Chief, Remote Sensing Division Phone: 301-713-2663

This data set is comprised of a hydro-flattened digital elevation model (DEM). The total area collected for Horry County, SC for this project is approximately 1092 square miles. Lidar data was collected and processed to meet the requirements of the project task order. The lidar collection was a collaborative effort between two data acquisition firms. While Woolpert was responsible for collection of the majority of the county, the coastal portion of the data was collected by Quantum Geospatial and is detailed in the processing steps of the metadata. Lidar data is a remotely sensed high resolution elevation data collected by an airborne platform. The lidar sensor uses a combination of laser range finding, GPS positioning, and inertial measurement technologies. The lidar systems collect data point clouds that are used to produce highly detailed Digital Elevation Models (DEMs) of the earth's terrain, man-made structures, and vegetation. The task required the LiDAR data to be collected at a nominal pulse spacing (NPS) of 0.7 meters. The final products include classified LAS, four (4) foot pixel raster DEMs of the bare-earth surface in ERDAS IMG Format. Each LAS file contains lidar point information, which has been calibrated, controlled, and classified. Ground conditions: Water at normal levels; no unusual inundation; no snow. The bare earth DEMs along the coast may have a variance in the water heights due to temporal differences during the lidar data acquisition and will be represented in DEM as a seam-like anomaly. One coastal elevation was applied to entire project area. Due to differing acquisition dates and thus differing tide levels there will be areas in the DEM exhibiting what appears to be "digging" water features. Sometimes as much as approximately 2.5 feet. This was done to ensure that no coastal hydro feature was "floating" above ground surface. This coastal elevation will also affect connected river features wherein a sudden increase in flow will be observed in the DEM to accommodate the coastal elevation value. During Hydrologic breakline collection, Woolpert excluded obvious above-water piers or pier-like structures from the breakline placement. Some features extend beyond the apparent coastline and are constructed in a manner that can be considered an extension of the ground. These features were treated as ground during classification and subsequent hydrologic delineation. In all cases, professional practice was applied to delineate what appeared to be the coast based on data from multiple sources; Due to the many substructures and the complexity of the urban environment, interpolation and apparent "divots" (caused by tinning) may be evident in the surface of the bare earth DEM. In all cases, professional practice was applied to best represent the topography. The data received by the NOAA OCM are topographic data in LAS 1.2 format, classified as unclassified (1), ground (2), all noise (7), water (9), ignored ground (10), overlap unclassified (17), and overlap ground (18). Digital Elevation Models (DEMs) and breakline data are also available. Any conclusions drawn from the analysis of this information are not the responsibility of NOAA, the Office of Coastal Management (OCM) or its partners. Original contact information: Contact Org: Woolpert Phone: (937) 461-5660

NOAA contracted with Spencer B. Gross, Inc. (SBG) to obtain airborne Lidar of Willapa Bay, Washington during low tide conditions. The Lidar data was processed to deliver topographic surface elevation data of the exposed intertidal flats and surrounding terrestrial areas. Original contact information: Contact Org: NOAA Office for Coastal Management Phone: 843-740-1202 Email: coastal.info@noaa.gov

Many different partners and groups, and several Center-led data projects, have contributed to the lidar data collection housed and distributed by the NOAA Office for Coastal Management. The data span more than two decades and were collected using many different sensors. The collection includes data from topographic and bathymetric lidar sensors. Data are available for all of the coastal states and range from shoreline strips to full county coverage. The products have been delivered to the Center in various formats, projections, datums, and units. Once received, the data are reviewed, checked for errors, and standardized to LAZ format, geographic coordinates and ellipsoid heights in meters. Data are on a NAD83 or ITRF realization depending upon the collection specifics.

The National Oceanic and Atmospheric Administration (NOAA) has the statutory mandate to collect hydrographic data in support of nautical chart compilation for safe navigation and to provide background data for engineers, scientific, and other commercial and industrial activities. Hydrographic survey data primarily consist of water depths, but may also include features (e.g. rocks, wrecks), navigation aids, shoreline identification, and bottom type information. David Evans and Associates, Inc. (DEA), in conjunction with Geomatics Data Solutions and Quantum Spatial, Inc., conducted hydrographic lidar survey operations along the New Jersey coast, from Barnegat Bay to Hereford Inlet. Survey H12606 was conducted in accordance with the Statement of Work, Hydrographic Lidar Surveying Services (SOW), June 2013 and Hydrographic Survey Project Instructions, June 18, 2013 for OPR-C308-KRL-13. Nine potential survey areas were identified, however, only three areas were surveyed. Areas 1, 2, and 6 were selected. Data were collected from April 1 - 3, 2014 using the Chiroptera Lidar system. Original contact information: Contact Org: Hydrographic Surveys Division, Office of Coast Survey, National Ocean Service, NOAA, U.S. Department of Commerce Phone: 301-713-3028 Email: HSD.Inquiries@noaa.gov

This data set includes data collected in August 2000 and covers coastlines of the states of South Carolina and North Carolina. Laser beach mapping uses a pulsed laser ranging system mounted onboard an aircraft to measure ground elevation and coastal topography. The laser emits laser beams at high frequency and is directed downward at the earth's surface through a port opening in the bottom of the aircraft's fuselage. The laser system records the time difference between emission of the laser beam and the reception of the reflected laser signal in the aircraft. The aircraft travels over the beach at approximately 60 meters per second while surveying from the low water line to the landward base of the sand dunes. Original contact information: Contact Org: NOAA Office for Coastal Management Phone: 843-740-1202 Email: coastal.info@noaa.gov